Select this and the print head will physically move so that you can inspect it. You will have to move the print head up or down depending on this information. Print Head HeightĬheck the wooden label for your material roll, it should note High or Low. Also, if the roll is extremely heavy, it may cause an error in the motors, you can prevent this by manually unspooling some of the material in the back of the machine, so the motors won't have to pull on the whole roll. Note : Some material rolls are really heavy! You may need a second person to safely remove the material. If installed correctly, the machine will display the correct distance between the two edge rollers, signifying your print area. Once the material is locked down, the machine will measure the distance between the two edge rollers.And the end rollers are on the edge of your material, lower the black lever (Found on the front left). Lock the material : Once all the rollers are in the correct position (Under the blue rectangles).If you are using a smaller material, you may need to remove some of the rollers by sliding them over to the orange zone and pulling the extras out. Make sure these are on the edge of your material. The machine reads these squares to determine the edge of the print area. The two end rollers should have an extra blue square on them. Each roller has to be under one of the blue strips found above the rollers. ![]() There are 7 rollers that hold down the material. Setting up the Rollers : Maker sure the black lever is in the up position (Unlocked).Feed the Material through the rollers from the back to the front.Two black rings can be moved to sandwich the Wheeled material asembly.Take the completed Material-Wheel assembly and place it into the back of the machine.Next, tighten the black nobs as tight as you can, to secure them to the material roll.Tap the ends, to make sure they are as far into the roll as possible. Take the two clear plastic wheels and insert them into the ends of the rolls.Choose your new material, inspect the wooden Label for important information (Head Height, Cut Options) and place it onto the Velcro above the control panel found on the front right of the machine.Take the wooden material label from the front of the machine and place it on top of the roll.Place the roll back into the storage racks and tape the material to it's self, so that the roll stays together.Flip the material and unscrew and remove the other material wheel. Rest one end on the ground, unscrew the black nob on the Material wheel to release and remove the Material Wheel.Walk to the back of the machine and lift the material out of the machine.The black lever on the front left side of the machine, unlocks the rollers.The oils on your hands can leave marks that affect print quality. It is important to wear nitrile gloves when changing material. Check the label and then double check the material, by lifting up a corner, to make sure your are actually using sticker material. It is easy to mix this up with regular white non-sticker vinyl. This material takes color well and is used to make Vinyl Stickers. The most popular material at Pier 9 is White Vinyl Sticker. ![]() Please keep material labeled correctly. Each roll of material should have a wooden tag with : Material Name, Head height, Cut options. ![]() We store our print materials on two rolling carts.
0 Comments
Leave a Reply. |